Pori Energia Oy is investing for new biomass power plant in Aittaluoto. The construction of the new power plant will be completed by April 2020 and once in operation it will replace some of the boiler capacity at Aittaluoto. Capacity of the boiler will be around 90 MW and it will supply heat to the city of Pori, process steam to neighbouring industrial clients and power to the grid. The new plant uses biofuels, peat and can also use solid recovered fuel (SRF). This supply consists of LP1 Piping contract includes following systems:
— district heating piping (1,6 MPa, 130 degC),
— carbon steel,
— DN size up to 400 (estimated mass 30 000 kg + supports).
Määräaika
Tarjousten vastaanottamisen määräaika oli 2018-11-30.
Hankinta julkaistiin 2018-11-14.
Toimittajat
Seuraavat toimittajat mainitaan hankintapäätöksissä tai muissa hankinta-asiakirjoissa:
Kohde Hankinnan laajuus
Otsikko: LP1 Piping, District Heating
101007990-F0054
Tuotteet/palvelut: Putket ja putkistot📦
Lyhyt kuvaus:
“Pori Energia Oy is investing for new biomass power plant in Aittaluoto. The construction of the new power plant will be completed by April 2020 and once in...”
Lyhyt kuvaus
Pori Energia Oy is investing for new biomass power plant in Aittaluoto. The construction of the new power plant will be completed by April 2020 and once in operation it will replace some of the boiler capacity at Aittaluoto. Capacity of the boiler will be around 90 MW and it will supply heat to the city of Pori, process steam to neighbouring industrial clients and power to the grid. The new plant uses biofuels, peat and can also use solid recovered fuel (SRF). This supply consists of LP1 Piping contract includes following systems:
— district heating piping (1,6 MPa, 130 degC),
— carbon steel,
— DN size up to 400 (estimated mass 30 000 kg + supports).
1️⃣
Suorituspaikka: Satakunta🏙️
Pääkohde tai suorituspaikka:
“Existing Aittaluoto power plant Site address: Kuninkaanlahdenkatu, 28100 Pori, Finland”
Hankinnan kuvaus:
“Scope of work includes:
— pipes and pipe parts, prefabrication and installation,
— installation of piping related equipment, for example valves and...”
Hankinnan kuvaus
Scope of work includes:
— pipes and pipe parts, prefabrication and installation,
— installation of piping related equipment, for example valves and filters,
— primary and secondary supports (tertiary superstructure by building contractor),
— scaffolding,
— all needed documentation according PED 2014, EN13480.
The following detail design is included in the Suppliers's scope of work:
— final stress analysis and strength calculations, the Purchaser will deliver preliminary stress analysis,
— non-standard pieces calculation and workshop drawings,
— the Supplier will make detail design to the Purchaser's PDMS 3D-model on the Purchaser's preliminary design,
— detail isometric drawings,
— detail support drawings.
Note! Piping supplier is the fabricator of the piping and shall give CE-marking of its scope of work according PED2014. The design, all works, testing and inspections shall be done according to EN13480.
Näytä lisää Myöntämisperusteet
Hinta ei ole ainoa myöntämisperuste, ja kaikki perusteet ilmoitetaan ainoastaan hankinta-asiakirjoissa
Sopimuksen, puitesopimuksen tai dynaamisen hankintajärjestelmän kesto
Jäljempänä oleva aikataulu on ilmaistu kuukausina.
Kuvaus
Kesto: 20
Tietoa vaihtoehdoista
Vaihtoehdot ✅
Vaihtoehtojen kuvaus:
“Low pressure LP2 Piping including (estimated mass 12 000 kg+ supports):
— spray water,
— DH condensate,
— main condensate,
— raw water,
— makeup,
— demi...”
Vaihtoehtojen kuvaus
Low pressure LP2 Piping including (estimated mass 12 000 kg+ supports):
— spray water,
— DH condensate,
— main condensate,
— raw water,
— makeup,
— demi water,
— closed cooling water,
— compressed air,
— light fuel oil,
— chemical dosing,
— sampling.
Oikeudelliset, taloudelliset, rahoitukselliset ja tekniset tiedot Osallistumisehdot
Luettelo ja lyhyt kuvaus olosuhteista:
“Pori Energia is entitled to exclude a Candidate that does no meet the criteria set forth below, or gives false information to Pori Energia.
(1) The...”
Luettelo ja lyhyt kuvaus olosuhteista
Pori Energia is entitled to exclude a Candidate that does no meet the criteria set forth below, or gives false information to Pori Energia.
(1) The Candidate or a person having representation, decision-making or supervisory rights with respect to the Candidate, as well as the subcontractors used by the Candidate, have not been declared guilty in offences of corruptive nature, in fraudulent actions in financial matters, in money laundering or participation in criminal organization by a valid court judgement that appears from the criminal record.
(2) The Candidate has not been declared insolvent, its business activities have not been suspended or discontinued or legal proceedings have not been started on the Candidate’s bankruptcy or it has not been found out that up to the expected completion date of the contract the Candidate is going to be liquidated.
(3) The Candidate does not have tax or state compulsory social insurance payment debts in Finland or in another country where it is registered or in the country of its residence.
(4) The Candidate is registered to the Trade Register, Commercial register or equal register of its country of incorporation:
— copy of the registration certificate issued by the relevant institution in Finland or the country of the Candidate’s incorporation must be submitted. Contractor’s Obligations and Liability will be checked and it must be fulfilled before contract can be signed (According to the Act 1233/2006). If the Candidate is a consortium, each member of the consortium shall fulfill these general criteria. Also possible subcontractors shall fulfill such criteria.
Näytä lisää Taloudellinen ja rahoituksellinen asema
Luettelo ja lyhyt kuvaus valintaperusteista:
“Criteria(s) to be fulfilled:
— the company's turnover need to be at least seven million euros (7 000 000 EUR) during the last 3 years. In addition, the...”
Luettelo ja lyhyt kuvaus valintaperusteista
Criteria(s) to be fulfilled:
— the company's turnover need to be at least seven million euros (7 000 000 EUR) during the last 3 years. In addition, the cumulative operating income must be at least two (2) % of the cumulative turnover over the last 3 years.
Document(s) to be submitted:
— statement signed by the Candidate concerning the average financial turnover of the Candidate excluding VAT for the period of last three (3) financial years (2015, 2016 and 2017/3 latest financial years of the Candidate). Candidates that have been established later shall submit the aforementioned documents for the period of operation,
— financial statements of the Candidate for the period of last three (3) financial years (2015, 2016 and 2017/3 latest financial years of the Candidate).
Candidates that have been established later shall submit the aforementioned documents for the period of operation. The contracting entity reserves the right to make a credit risk control checking from a solid corporation e.g Suomen Asiakastieto, Bisnode or similar and if the risk value is bigger than 2, the candidate can be excluded.
Näytä lisää Tekninen ja ammatillinen pätevyys
Luettelo ja lyhyt kuvaus valintaperusteista:
“1) Minimum Reference Requirement: These references refer to the minimum references which affect the selection of the candidates. The candidate must have...”
Luettelo ja lyhyt kuvaus valintaperusteista
1) Minimum Reference Requirement: These references refer to the minimum references which affect the selection of the candidates. The candidate must have experience during the last five (5) years (6/2013 - 6/2018) of deliveries from similar power plant piping installation and under similar conditions than in this acquisition (including full responsibility for engineering, manufacture, installation and commissioning per reference) that have been taken into commercial operation and fulfill the EN-norms and the PED regulations;
2) The candidate must have a valid certified quality assurance system (ISO-9001 or equivalent);
3) Comparative References: These references refer to non-minimum references which affect the candidate comparison and must be different references than those indicated by the candidate to meet the minimum reference requirements (Evaluation Point 1). The experience of the candidate without time constraints of deliveries of subprocesses from similar power plant piping and under similar conditions than in this acquisition (including full responsibility for engineering, manufacture, installation and commissioning per reference) that have been taken into commercial operation. The total number of the references of the candidate are taken into account in the comparison, provided that the reference contains a district heating/power plant piping and that at least one of the requirements listed below is met (they must be different references than the candidate has indicated to meet the minimum reference requirements (evaluation point 1)). The equivalence and number of references are evaluated based on the written report submitted by the candidate. The candidate must complete the reference form attached to the procurement notice (Appendix 2);
4) The contractor must have a maintenance and spare parts center in Europe and maintenance must be available in Pori within forty eight (48) hours of contacting.
Näytä lisää Osallistumisehdot
Vaadittavat vakuudet ja takuut: Will be specified in call for tenders.
Tärkeimmät rahoitusehdot ja maksujärjestelyt ja/tai viittaus niitä koskeviin säännöksiin: Will be specified in call for tenders.
Oikeudellinen muoto, joka sen taloudellisten toimijoiden ryhmittymän, jonka kanssa hankintasopimus tehdään, on otettava: Limited company (Ltd. or Plc.) or equal.
Menettely Toimenpiteen tyyppi
Neuvottelumenettely, johon liittyy edeltävä kilpailuttaminen
Hallinnolliset tiedot
Tarjousten tai osallistumishakemusten vastaanottamisen määräaika: 2018-11-30
13:00 📅
Kielet, joilla tarjoukset tai osallistumishakemukset voidaan jättää: englanti 🗣️
Kielet, joilla tarjoukset tai osallistumishakemukset voidaan jättää: suomi 🗣️
Jäljempänä oleva aikataulu on ilmaistu kuukausina.
Vähimmäisaika, jonka kuluessa tarjoajan on pidettävä tarjous voimassa: 3
Täydentävät tiedot Lisätietoja
“The contracting entity reserves the right to invite to the procurement procedure a minimum of two (2) and maximum of three (3) bidders. If there is more...”
The contracting entity reserves the right to invite to the procurement procedure a minimum of two (2) and maximum of three (3) bidders. If there is more than three (3) bidders the contracting entity reserves the right to select those bidders that have the largest number of similar references during the last five (5) years. The candidate must meet all the requirements set out in Section III.1.3. subsections 1 and 2. Any qualification is made in such a way that the candidates to be selected to the bidding process are ranked based on the number of references in Section III.1.3 Technical and professional ability subsection 3. If two or more candidates have the same number of references calculated based on the subsection 3, they are ranked based on the number of references set out in subsection 1 that exceed the mandatory minimum requirements. The equivalence and number of references are evaluated based on the written report submitted by the candidate (reference form, Appendix 2).
Ilmoitus tehdystä sopimuksesta (2019-03-28) Hankintaviranomainen Nimi ja osoitteet
Nimi: Pori Energia Oy, A2020-projekti
URL: http://www.porienergia.fi🌏
Kohde Hankinnan laajuus
Lyhyt kuvaus: Power plant low pressure piping
Hankinnan kokonaisarvo (ilman arvonlisäveroa): EUR 1 515 029 💰
Kuvaus
Lisätuotteet/palvelut: Putket ja putkistot📦
Hankinnan kuvaus:
“Low pressure LP1 Piping contract includes following systems:
— District heating piping (1,6 MPa, 130 degC), carbon steel, DN size up to 400 (estimated mass...”
Hankinnan kuvaus
Low pressure LP1 Piping contract includes following systems:
— District heating piping (1,6 MPa, 130 degC), carbon steel, DN size up to 400 (estimated mass 30 000 kg + supports). Scope of work includes:
— Pipes and pipe parts, prefabrication and installation,
— Installation of piping related equipment, for example valves and filters,
— Primary and secondary supports (tertiary superstructure by building contractor),
— Scaffolding,
— All needed documentation according PED 2014, EN13480 The following detail design is included in the Suppliers's scope of work:
— Final stress analysis and strength calculations, the Purchaser will deliver preliminary stress analysis,
— Non-standard pieces calculation and workshop drawings,
— The Supplier will make detail design to the Purchaser's PDMS 3D-model on the Purchaser's preliminary design,
— Detail isometric drawings,
— Detail support drawings.
Näytä lisää Tietoa vaihtoehdoista
Vaihtoehtojen kuvaus:
“Low pressure LP2 Piping including (estimated mass 12 000 kg + supports):
— Spray water,
— DH condensate,
— Main condensate,
— Raw water,
— Makeup,
— Demi...”
Vaihtoehtojen kuvaus
Low pressure LP2 Piping including (estimated mass 12 000 kg + supports):
— Spray water,
— DH condensate,
— Main condensate,
— Raw water,
— Makeup,
— Demi water,
— Closed cooling water,
— Compressed air,
— Light fuel oil,
— Chemical dosing,
— Sampling.